-
- 14 MarHyperbody presents at RAM/ramfoundation exhibition "T.O.P. UP" opening on the 16th of March 2014
- 08 MarKeynote Lecture by Kas Oosterhuis at the 11th International Convention of Architecture in Budapest
- 28 Febprof. Kas Oosterhuis lectures at MC2014 conference - Grenoble, France
- 27 FebDr. Nimish Biloria appointed as Technical Program Committee member of SEC2014 conference
- 17 FebDr. Nimish Biloria publishes article: Inter-performing morphologies in the Architecture Institute of Korea Magazine
- 07 FebDr.-Ing. Henriette Bier lectures on Robotic Buildings at the Institute of Experimental Architecture, University of Innsbruck, Austria
- 05 FebDr.-Ing. Henriette Bier lectures on Robotics in Architecture at the chair for Building Realisation and Robotics at TUM, Germany
- 04 FebDr.-Ing. Henriette Bier and Ir. Chris Kievid join the Delft Robotics Institute delegation visiting potential Horizon 2020 partners in the Munich area
- 24 JanFinal Review MSc1 Design Studio: 2628CLIMATOR
- 11 JanAchilleas Psyllidis publishes an article in the ATLANTIS Magazine
-
-
From 4th to the 18th of November, Hyperbody organizes a Parametric Design Design and Prototyping workshop at Southeast University of China, located in Nanjing City China. Tutor: Han Feng (PhD candidate, Hyperbody, TU Delft, the Netherlands)
The relation between form and component is one of the hot spots of Digital Architecture. The popular workflow starts with a given form, and then populates a set of customized components to finalize the geometry . The advantage of this workflow lies in its efficiency, say by simplifying the complex design problem into smaller ones (form design, surface subdivision design and component design), effective local strategies can be devised and applied. This workshop will take a brief examination of the form2component workflow, and then focus on an inversed workflow, say component2form, which means starts with the design of a set of parametric component with clear connectivity logic, and then play with these fabricated component to realize form finding in a bottom up manner.
In the hands-on phrase of this workshop, students will work in small groups of 3-5 persons. Each group will design and produce their own physical components and creatively assemble them to search for the final form. During this physical form finding process, students will also apply the CAD model made in this workshop to fast produce the needed components. Each group shall finish two physical models out of the same set of components for comparison.